[Glade-users] New Installation from Librecore

Tristan Van Berkom tristan.van.berkom at gmail.com
Sun Jun 5 08:00:51 UTC 2016


Hi,

It's hard to say whats going wrong, what version of Glade were you
previously using ? If you were using Glade 3.8.x - then you need to
continue using Glade 3.8.x (which is parallel installable with Glade
>= 3.10) which generates XML for the older libglade format as well as
GtkBuilder format for GTK+2.x.

>From your message, I suspect that you are looking at an older code
base which still uses libglade and GTK+2, but as I said it's hard to
say whats going on without further information.

What were the warnings that you saw when running your program ?

In your glade file, does it say <glade-interface> at the top level ?
or <interface> ?

What api are you using to load the glade file through your Ada
bindings, bindings to libglade or to GTK+'s GtkBuilder ?

Cheers,
    -Tristan





On Sun, Jun 5, 2016 at 4:09 PM,  <bertus.dries at planet.nl> wrote:
> I just made a new installation from Librecore of GPS and GtkAda. In the
> GtkAda installation a new version of glade was introduced (3.16.1). When I
> tried to run in GPS a programwhich uses a .glade file I got several
> warnings. Then I tried via properties to change the toolkit version to 3.10
> and my program (in the meantime rebuild ). My program did not recognized the
> .glade file as a correct file.
>
> Which is the correct combination I should use with the new installation. I
> am running on Windows 10.
>
> L. Dries
> _______________________________________________
> Glade-users maillist  -  Glade-users at lists.ximian.com
> http://lists.ximian.com/mailman/listinfo/glade-users


More information about the Glade-users mailing list